December 4, 2020 – Decorating homes and businesses with holiday lights and decorations is a long-standing tradition around holidays. Unfortunately, these same decorations may increase the chances of fire.
Based on National Fire Protection Association data, on average, one of every 32 reported home fires that began with a Christmas tree resulted in a death, compared to an average of one death per 143 total reported home fires. Electrical distribution or lighting equipment was involved in 40% of home Christmas tree fires.
The Midland Fire Department offers the following advice for picking, placing, and lighting your tree, decorations, and holiday lights:
• Ensure that Christmas trees or holiday decorations do not block exits. In the event of fire, time is of the essence. A blocked entry/exit puts you and your family at risk.
• If you choose a fresh tree, make sure the green needles don’t fall off when touched; before placing it in the stand, cut 2” from the base of the trunk.
• Needles on fresh trees should be green and hard to pull back from the branches. Needles should not break if the tree has been freshly cut. The trunk should be sticky to the touch. Old trees can be identified by bouncing the tree trunk on the ground; if many needles fall off, the tree is older and has most likely dried out, which is a fire hazard.
• Make sure the tree is watered daily. Well-watered trees are not a problem, but a dry and neglected tree can be.
• Avoid placing your tree close to a heat source such as a fireplace or heating vent. The heat will dry the tree out, causing it to more easily ignite by heat, flame, or sparks. Be careful not to drop or flick cigarette ashes near a tree. Don’t put up your live tree too early or leave it up for longer than two weeks.
• Before putting up holiday lights, inspect them for frayed wires, bare spots, gaps in the insulation, broken or cracked sockets, and excessive kinking or wear. Use only lighting listed by an approved testing laboratory, such as UL.
• Do not link more than three light strands, unless the directions indicate it is safe. Make sure to periodically check the wires; they should not be warm to the touch.
